Assembly instructions
Mounted in a minute
No tools, no bending. Here is how to attach the Comfort I and load your tree safely.
Step by step
- 1
Check your tow hitch
50 mm ball, made of GG52 or St52, D-value at least 7.6 kN. Not suitable for aluminium or GGG40 hitches.
- 2
Attach the carrier
Place the quick coupling on the tow ball and tighten the screw coupling by hand until the carrier sits firmly.
- 3
Mount the licence plate
Attach your licence plate to the carrier. With the LED plate holder, plug the 13-pin connector into your trailer socket.
- 4
Insert the tree
Slide the netted tree trunk-first into the vertical tube. The rubber insert protects the trunk.
- 5
Tighten the strap
Pull the 35 mm ratchet strap tight around the tree until it stands firmly upright.
- 6
Loop the safety leash
Wrap the safety leash around the tree for extra stability — then off you go, at max. 70 km/h.

Taking it off
Loosen the strap, lift the tree out, open the screw coupling and take the carrier off the tow ball. It fits in the boot until next December.
Connecting the LED plate holder
Plug the 13-pin connector (cable approx. 1 m) into your vehicle's trailer socket. Check that the plate lighting works before you drive off.
Documents
Prefer to read it all? Download the full operating manual and the safety instructions.